# No Lights for WS2815, WLED and Dig-Quad

**URL:** <https://wled.discourse.group/t/no-lights-for-ws2815-wled-and-dig-quad/5871>\
**Category:** Questions\
**Created:** [August 29, 2022, 2:50am UTC](https://wled.discourse.group/t/no-lights-for-ws2815-wled-and-dig-quad/5871 "2022-08-29T02:50:04Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![VanishingHope](https://avatars.discourse-cdn.com/v4/letter/v/4491bb/32.png) [@VanishingHope](https://wled.discourse.group/u/VanishingHope)\
**Post date:** [August 29, 2022, 2:50am UTC](https://wled.discourse.group/t/no-lights-for-ws2815-wled-and-dig-quad/5871/1 "2022-08-29T02:50:04Z")

</div>

Attempting my first LED project: Dig-Quad (v3), WS2815 12v 5m w/ 60 LED/m having flashed WLED 0.13.3.

Powered everything on and have the Dig-Quad light on and the ESP32 board light. 12.03v out from the PSU, 12.00v out from the LED connector attached to the Dig-Quad. 11.65v out at the tail of the LED strip.

Data cable (green) is in position LED1. Data cable for backup (blue) is GND.

I have WLED setup for WS2815 (12mA) and length of 300. Tried on 2 sets of new LED strips.

I’m not sure where to go next to determine where I went wrong. Not sure this is a Dig-Quad setup issue, a WLED setup issue or both. 🙂 Any guidance in the right direction would be appreciated!

---

<div class="post-metadata">

**Author:** ![VanishingHope](https://avatars.discourse-cdn.com/v4/letter/v/4491bb/32.png) [@VanishingHope](https://wled.discourse.group/u/VanishingHope)\
**Post date:** [August 29, 2022, 3:31am UTC](https://wled.discourse.group/t/no-lights-for-ws2815-wled-and-dig-quad/5871/2 "2022-08-29T03:31:35Z")

</div>

Ok. Decided to move the data cable to LED4 position on the Dig-Quad, and changed my GPIO to 4 in WLED. Lights are on. I’ll try some other configs for this board. Assuming this means there’s a potential issue with LED1 on my pre-assembled board.