# Roccomendations for Narrower ESP32 Board

**URL:** <https://wled.discourse.group/t/roccomendations-for-narrower-esp32-board/14622>\
**Category:** Hardware\
**Created:** [July 1, 2025, 11:34pm UTC](https://wled.discourse.group/t/roccomendations-for-narrower-esp32-board/14622 "2025-07-01T23:34:08Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![Jinx](https://avatars.discourse-cdn.com/v4/letter/j/c6cbf5/32.png) [@Jinx](https://wled.discourse.group/u/Jinx)\
**Post date:** [July 2, 2025, 3:24am UTC](https://wled.discourse.group/t/roccomendations-for-narrower-esp32-board/14622/4 "2025-07-02T03:24:39Z")

</div>

I would solder it on [prototype board](https://www.amazon.com/Rindion-Compatible-Prototype-Electronics-Soldering/dp/B0DBZ1BXFZ) If doing this I would solder female [pin headers](https://www.amazon.com/Ruibapa-2-54mm-Connector-Breakaway-P-037-22pcs/dp/B0BX85CWJ8) on to slot the Esp into in case you ever want to remove it/replace it. I would also add a [dip socket](https://www.amazon.com/uxcell-2-54mm-Soldering-Socket-Adaptor/dp/B07H3WQYRQ) for the level shifter, again in case you want to remove it. Pin headers and Dip socket optional but makes things ALOT easier for replacement.

or

If soldering is an issue I would try to wire anything I could using wago’s or screw terminals (like offered on the breakout board). A multi port level shifter would be the hard part of that. You would either have to use induvial ones like [Quindor’s](https://quinled.info/quinled-data-booster/) data booster’s, [Falcon F-Amp’s](https://pixelcontroller.com/store/accessories/53-famp.html) or if you could handle a small bit of soldering you could look at the 4 port shifter from [RGB2Go](https://rgb2go.com/collections/controllers/products/level-shifters-sn74ahct125-pack-of-4) \* Actually with that RGB2Go shifter you could likely use [JST SM](https://www.amazon.com/mxuteuk-Female-Connector-Adapter-Electrical/dp/B083GR7FQF) connectors and slide them on the pins, if you rather not solder.

-Soldering would be my preferred solution as it provides the most permanent solid solution. depending on the project and LED choices… I would use [solder seal](https://www.amazon.com/Kuject-Connectors-Terminals-Waterproof-Automotive/dp/B0B6BQJJDS) connectors to connect the wires to the pixels

Note: My Amazon links were quick selections. You may be able to find lower cost items with more searching.

---

_[View the full topic](https://wled.discourse.group/t/roccomendations-for-narrower-esp32-board/14622)._