MQTT presets

Hello,

I’ve just found this fantastic LED controller and been tinkering with the MQTT part, I’ve read the ongoing re-development of MQTT for WLED and that things will change soon.

I make Acrylicglass edge-lit LED signs (not a full time employment) and I’d like to switch between to stored presets, in fact toggle between them.

I’ve got things connected and able to switch on and off from node red.

So is it or will it be possible to trigger stored presets via MQTT? and separately, is it possible to boot to a single preset and not to the preset cycle?

Thanks
Ian

Put the slot selection into a macro (&PL=x) and set that as your boot macro.

Ok Thanks, I’ll give it a try