**** UPDATED 22.01.2022 **** I can’t find any useful tutorial, to bring WLED on the WT32-ETH01 Chip. I played around a couple hours and finally did it :smile: Maybe this tutorial will Help someone… Hardware: WT32-ETH01 USB → TTL Flasher Wires Software: WLED BIN for the ESP32 (from WLED Github…

Anyone not getting the upload from Xlights changing the WLED settings page should use Firmware v0.13b5 as v0.13 & v0.13.1 not working with Controller Upload.

I’ve only tested xlights for a short time, but I think Controller Upload is for devices like the Kulp and such where you are uploading a sequence. Not for real-time control.

I saw that. Latest xlights actually warns you. Haven’t found 0.13.2 yet – I assume you have to compile yourself?

I was unable to get this to work using Espressif’s download tool and a CP2102-based serial adapter. Tried multiple times with 3 different ETH01 boards and also tried the non-ethernet version and v0.12 as suggested above. Everything seemed to work and the flashing tool reported success but the acce…

6 Port, already assembled, with or without the ETH-01 Wasatch Pixels Six Port Ethernet Controller w/WLED from Wasatch Pixels on Tindie

Just want to thank all on this thread, I was able to get my WT32-ETH01 up and running with WLED! Notes: I was able to use an ESP8266 in place of the USB TTL adapter, thanks to @etanremlap 's helpful pin suggestions. Only difference for me was using RST > GND on the ESP8266 (since my model is the E…

I managed to flash the device. I tried ESP32 and ESP32 with ethernet. I dont get the WLED-AP. I even flashed through the web installer. Any suggestions?? Could really use some help here. Im new to the microcontrollers

Not many people use those, so sit tight.

i know this is an old thread but i got one of these yesterday, and flashed via web installer (check ethernet). rebooted, connected to wled-ap, under wifi select wt32-eth01. DONT enter wifi info, save, log into your router, check attached devices to find IP, good to go. it wont show up in the app…

I have the same problem. I flahsed through we and many other flashing tools. Can’t get wled ap to show in the network list. Any solutions?

WT32-ETH01 (LAN+WiFi) (Flash Tutorial)

Hardware

kilrah March 21, 2024, 11:11pm 51

FWIW I have about 15 of them working just fine with Ethernet. Add the 1uF ceramic cap between EN and GND and make sure to actually enable Ethernet in settings.

Topic		Replies	Views
Cannot install on 2 different ESP32 devices Issues	16	1450	December 29, 2023
WT32-ETH01 - does it work Hardware	4	3185	December 29, 2021
WT32-ETH01 hangs on boot after PSU power up Hardware	25	10302	October 2, 2024
Cannot get WLED flashed on ESP32-Mini-1 Issues	11	602	December 4, 2024
wESP32 revision 7 ETH_PHY_RTL8201 support Hardware	6	1279	March 19, 2025

WT32-ETH01 (LAN+WiFi) (Flash Tutorial)

Related topics