Diguno pir gpio

Good afternoon,

I have been relying on Home Assistant to switch my LED’s on and off. I want to try using a PIR directly on a DigUno, but there are no GPIO pins available to plug a DuPont connector onto - they are all shielded. Must I solder a jumper onto an ESP32, or can someone point me in another direction with the DigUno. I already compiled WLED with -D USERMOD_PIRSWITCH, and it shows up in the UI.

Thank you.

Looks like any of the Q1-Q4 QuinLED-Dig-Uno Pinout Guide - quinled.info

1 Like

Thank you. That’s what I was thinking, but I couldn’t find that page.

1 Like

Yea Quindor’s site is a bit challenging to navigate.

1 Like