Matrix: Two lines are running in the wrong direction

Issues
1

Hello everyone,

I am planning to install a larger LED matrix with 1944 LEDs.
Before I spend so much money I wanted to test it on something smaller.

Each 10x3 LEDs are connected to a single GPIO.

My problem is, the middle lines of panel 1 and 2 are running in the wrong direction, all others run in the right direction. Since its in the middle of a panel, i dont understand why this is happening.

Here is an example when scrolling a 1:

matrix
matrix673×2623 290 KB

To create the matrix I used the Matrix Generator and only adjusted the 1st LED setting.

Does anyone have an idea why this is happening?

Best regards
Michael

2

Sounds like you just need to check the serpentine box.

3

@Artacus
Thanks for your reply. That was it.
Thanks.