A1-SLWF-03 only fully starts after log download

Issues
1

This controller was working fine until I moved it. Here is what I have observed:

The blue power light no longer lights, but the board is powered.

It will not connect to the WiFi or start the AP

If I use the web installer, I install firmware and the unit will run.

Afterwards, it will fail to start if power is cycled.

Instead of sending new firmware, I can get it to start by opening the console window and waking it up.

I am seeking some guidance as I want to have this plugged into a power supply, not a computer.

2

Never heard of that device. You may want to contact the place you got it from.

3

This is a ESP32-based board. I have reached out to the seller to see if there is something perhaps not configured correctly.

In further testing, it appears that wled is simply not autobooting. Even resetting the console brings it to life. I have a second board of the same type that works fine, but admittedly requires a little finesse to get it back up and working after a power cycle.

I saw another post about a problem where it was a bootloader problem, but I’m going to hold off till A hear back.