Hello everyone, I flashed the WLED application to my WT32-ETH01 and used the wireless connection to set the ethernet type in the WLED settings to “WT32-ETH01”. Now I like to create a direct wireless connection using ethernet. So the WT32-ETH01 is connected with an ethernet cable to my laptop over a…

On the first stage you missed that step. Instead of using wi-fi you have to choose ethernet connection and type of your interface.

Do you mean the step, shown in the picture? Otherwise, how can I do this? [Capture]

Yes. According to your post you connected to wi-fi. Re-flash your board and start from this step.

But what comes next? There is still the Problem with the IP address. I use the command window to type in “ipconfig” and see the IP4 Address of the controller. But I cant open a connection with this address.

I think you’re confusing some network concepts. On a PC, opening a cmd window and typing “ipconfig” will show you the network information for your PC That IP address has nothing to do with your ESP32 board. You have to configure the ESP32 with a different IP on the same subnet as your PC.

I tried the following: I reinstalled WLED and set a WLAN connection. In the WLED settings: changed the Ethernet dropdown to “wt32-eth01” changed the ip address to 192.168.1.2 changed the subnet mask to 255.255.255.0 changed the gateway to 192.168.1.1 On the laptop settings: as shown in the pi…

Better to use DHCP and reserve address at your router to make it permanent.

How are you cabling things together? Eg; ethernet cable from laptop (192.168.1.3) to router (192.168.1.1), and ethernet cable from W32-eth01 (192.168.1.2) to router (192.168.1.1) Or you could be cabling the laptop directly to the W32-eth01, a different case. And then on your laptop, in a browse…

Update: I found the solution. It seems like the web installer was my problem. A friend of mine told me that sometimes the flushed files from the web installer is a little defective in sense of the ethernet connection. I used files from git to flash the same wled version and it worked. I created a n…

Hi Is there anyone who know a way to send artnet over Ethernet to the Eth01? Theres a case where i must wire it. But i’m not able to hack the code…

How to connect a WT32-ETH01 using ethernet?

Questions

lepeitschke May 29, 2024, 2:25pm 19

I did use the ethernet binaries. for me version 0.14.2 wasn’t working. But 0.15.0_b2 did the trick.

I can't get WLED to communicate over ethernet

Topic		Replies	Views
WT32-ETH01 - does it work Hardware	4	3206	December 29, 2021
Struggling with Ethernet Hardware	4	587	July 24, 2024
ESP32-ETH01 board Questions	4	511	May 22, 2023
Ethernet Connection Questions	9	5705	January 26, 2023
How to set the wired address for the wt32 eth01 Questions	2	544	April 29, 2024

How to connect a WT32-ETH01 using ethernet?

Related topics